LDX-020A Factory direct woodworking left and right teeth circular
saw blade grinding machine
Lidexin saw blade grinding machine What is the thickness of the granularity of the saw blade:
1,What is the thickness of the particle size of the saw blade of
the grinding machine? If the upper and lower cutting mode is used
in the processing process, the maximum initial contact surface of
the single crystal particles of the high speed steel saw blade can
reach the maximum particle tip thickness. On the contrary, when the
up and down mode is maintained, the diamond particle thickness
increases to the maximum value during the processing.
2,In this condition, the tensile deformation of diamond particles
mainly appears at the earliest stage, and the thickness of the tip
of the diamond particles is preferably reached and formed. The up
and down cutting modes result in very different grinding
characteristics. During the next cutting process, taking into
account the type of abrasive and binder as well as the cracking or
exposure of diamonds, high mechanical impact pulses will occur.
3,In the cutting process, the fracture of the igneous rock is close
to the bottom of the diamond particle, mainly because of the low
strength of the binding material of the high-speed steel saw blade.
Small and hard stone fragments appear after the cutting process.
| Technical parameter: |
| Processing saw blade diameter range: ￠100- ￠800mm |
| Saw blade aperture: ￠ 10-220mm |
| Saw blade thickness (steel plate): 1-12mm |
| Tooth pitch: 7-100mm |
| Tooth surface angle: 5 degrees to+20 degrees |
| Tooth top back angle: 1-20 degrees |
| Left and right inclination of teeth: tooth tip/tooth surface 20
degrees |
| Blade grinding stroke range: maximum 25mm (adjustable) teeth/minute |
| Grinding speed: 0.5-6mm/s |
| Working speed: maximum 20 teeth/minute |
| Grinding wheel size (outer diameter x hole): (￠ 125mm x ￠ 32mmX1mm) |
| Negative chamfer grinding: -15 degrees |
| Grinding wheel linear speed: 26m/s |
| Flow rate of coolant water pump: 501/min |
| Volume of coolant cylinder: 85L |
| Total power: 1.85 kW |
| Voltage: three-phase 380v |
| Mechanical weight: 700KG |
| Mechanical dimensions (length x width x height): 1500X1100X1700mm |
| Technical features: |
1. This equipment can grind aluminum TCT cutting alloy saw blades
and woodworking saw blades. It is easy to operate and can fully
extend the service life of TCT saw blades. Each blade can be reused
15-30 times. This equipment has received praise from many buyers.
|
